Posted by solomonon 2008/5/21 16:14:21 (2918 reads)
This is the latest CD-Pro2LF control kit. It utilizes a FPGA as the main controller to communicate with keypad, remote, LCD, and the transport unit. It includes a 4 X 20 LCD display, RC-5 receiver, high quality MOSFET PSU, individual keypad..........
Posted by bperboyon 2007/10/17 12:58:53 (2894 reads)
This little DAC is a very nice DAC to put together from Solomon at AudioDIYLab.com. I received the DAC board with all SMD components already soldered on and with a bag of parts to finish populating the board. My DAC-301 is fully populated, so there is one set of unbalanced and balanced outputs; the input is USB only.........
Posted by solomonon 2007/8/29 15:18:45 (10407 reads)
This is a new upgraded USB DAC kit. The main USB receiving chip PCM2706 will transits the I2S signal to an independent DAC chip PCM1798 in order to increase the sound quality. It has a on-board headphone amp using TI's high-end chip (TPA6120A2),on-board LPF (TI's OPA2227) and a pair of balanced signal output......
Posted by bperboyon 2007/4/2 23:31:14 (3006 reads)
This little DAC is a very nice kit to put together from Solomon at AudioDIYLab.com. I was one of a few people that received a free circuit board from Solomon, and I immediately purchased parts to begin construction. Before this, however, I did modify slightly which features my DAC-201 was going to have.....
Posted by solomonon 2007/3/21 3:29:58 (3074 reads)
This article will teach you how to use Quartus II programmer step by step, and download the new firmware into the SDAC-I using ByteBlaster download cable. (EPM570T100C5)........
Posted by solomonon 2006/10/16 17:50:56 (5137 reads)
Icarus is a modulized digital to analog convert(DAC) with build-in headphone amplifier. This DAC has 4 digital inputs , one headphone out, one pair of unbalanced out , and one pair of balanced out. It has been designed into two modules. The first module is a main board which has receiving, voltage regulator, and analog amplification circuitry. Second module (daughter board ) has the main DAC chip on it.
Posted by solomonon 2006/8/1 15:28:21 (7836 reads)
DIYer's dream "DIY High-End CD PLAYER". Here is a solution. Using our SDAC-I +CD-Pro2M, you will have a ultimate diy cd player. This cd player is not only a cd player. It can be switched into DAC only mode or CDP only mode. In both modes , the SDAC-I can output I2S format form sources. In CDP mode, the I2S output form CD-Pro2M goes directly into the SDAC-I......
Posted by solomonon 2006/7/24 5:24:23 (9605 reads)
This is a High-End 24bit/192Khz Over-Sampling DAC. It's based on TI's DAC chip(PCM1794). The board has two PCM1794 on it. Each chip can work at either stereo or mono mode. Each chip has a digital isolator (ADUM1400) in order to totally isolate form the main digital section. ........
Posted by solomonon 2006/7/24 2:49:27 (2926 reads)
This unique L1210/65 is same as the one with CD-Pro2M. The control kit comes with a power supply and a control board. The control board has a 4 x20 blue backlight LCD , 6 ALPS switches, and a lot of user defined I/Os. The power supply board has two independent positive voltage regulators ........
Posted by solomonon 2006/7/6 14:56:10 (7865 reads)
This unique CD-Pro2M control kit comes with a power supply and a control board. The control board has a 4 x20 blue backlight LCD , 6 ALPS switches, and a lot of user defined I/O. The power supply board has two independent positive voltage regulators ........
